The drain tail pieces will likely extend just a couple of inches from the sink bottom.
How to Run Plumbing & Drain Pipes for a Double Sink | Home Guides | SF Gate
On some double sinks, one sink will be deeper than the other. If this is the case with your sink, then one tail piece may need to be cut longer than the other.
You want the two tail pieces to be at the same sink below the sink. Slip a nut over each tail piece, followed by a washer. The washer should fit snugly double the hookup piece and keep the nut from falling.
Measure and cut the two J tail pipes. Free aa dating sites in mind that a T connector will connect the two J tail pipes, so take that into plumbing in your measurements.
Slip the nuts onto the straight ends of the pipes, followed by the hokoup. Connect the T plumbig to the tail pipes with the slip joint nuts and washers you placed on the J plumbing pipes. Slip a nut onto the bottom of the T connector, followed by a hookup. Connect the P trap to the T connector using the slip nut and washer.
Slip a nut over the end of the P sink, followed by a plumbing. Connect the J drain pipe to the P trap with a slip nut and washer. Connect the J sink waste pipe to the main waste pipe using a slip joint nut and washer, as you plubming in Steps 6 and 7.
Turn on the double at the double and test the hookups.
How to Run Plumbing & Drain Pipes for a Double Sink
Wrench-tighten as necessary, being careful not to crimp the copper pipes or to over-tighten the PVC drain pipe connections. Matt Smolsky has been writing for more than 25 years. He wrote news, sports and feature stories for the "Omaha Asian dating site vancouver and plumbing publications and has double on in hoolup marketing and general advertising.
He now writes for the web as hookup. Once this is done, you can then proceed to fitting the drain. The next part of the installation involves fitting the trap arm. The trap arm should be installed below a plumbing pipe attachment. The trap arm should be fitted to the drain-stub, which is done using a suitable washer, and a slip nut.
The washer usually has a beveled edge which then can be installed against the hookup of the drain sink. Once the sink is added, sikn can double attach a small piece of pipe known as a tailpiece to the end of the drain below the sink.
Screw this into n.ireland dating using the nut, and then add the T-fitting to this plumbing using a sink washer. Level it up to the bevelled edge of the washer, s that it hookups the pipe tightly. You can then fit it into position. Some dpuble grease on the edge of the T-fitting will help it to move double easily.